Rosslare AC-020 Manuel d'installation télécharger pdf (Page 10)

Wiring Instructions

Swipe Family Readers Installation Manual Page 10

5 Wiring Instructions

Mifare

Smart Card Fingerprint Swipe Sensor MOC Readers are

supplied with a 7- wire, 18-inch cable.

To connect the Reader to the Controller:

1. Prepare the Reader cable by cutting the cable jacket

back 1¼ inches, and by stripping the wires ½ an inch.

2. Prepare the Controller cable by cutting the cable jacket

back 1¼ inches, and by stripping the wires ½ an inch.

3. Splice the Reader pigtail wires to the corresponding

Controller wires (see Table 1), and cover each connection.

If the Tamper output is being utilized, connect the purple

wire to the correct input on the Controller.

5. Trim and cover all conductors that are not used.

Table 1: Wiring the Reader to the Controller

Color Wiring

Black/ Shield Ground

Red Vin

Green Data 0

White Data 1

Brown LED control

Orange Buzzer control

Purple Tamper

Note:

• The individual wires extending from the Reader are color-

coded according to the required Wiegand standard.

• When using a separate power supply for the Reader, this

supply and the Controller’s power supply must have a

common ground. A linear power supply is

recommended.

• Attach the cable Shield wire on the Reader to an earth

ground (best), or to a signal ground connection at the

panel or power supply end of the cable. This

configuration is best for shielding the Reader cable from

external interference.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Pas de commentaire

Rosslare AC-020 Manuel d'installation Page 10