Rosslare AC-215 Manuel d'installation télécharger pdf (Page 26)

Input and Output Connections

26 AC-215IP Hardware Installation Manual

When connecting a reader, the following should be defined:

Single door controller:

Door 1 – Reader 1 IN/OUT

Door 1 – Reader 2 OUT/ IN

Double door controller:

Door 1 – Reader 1 IN/OUT

Door 2 – Reader 2 IN/OUT

Use the AxTraxNG™ software to set the readers for IN or OUT use and to set

the data transmission format for each reader.

The reader’s tamper output connects to the access control panel's Reader-

Tamper input. If the reader is interfered with, an alarm can be generated.

The panel's Reader G.LED output activates the reader’s green LED input when

operating in "Card and PIN" secure mode. While this mode is in force, users

must enter a PIN on the keypad immediately after entering the card.

The controller activates the LED control for 2 seconds when an access granted

event occurs.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 37 38

Pas de commentaire

Rosslare AC-215 Manuel d'installation Page 26