Rosslare AC-215 Manuel d'utilisateur télécharger pdf (Page 10)

To configure АС-215 controller entrances do the following:

1. Go to the setting panel of the Rosslare entrance object (Figure 3.5-2).

Figure 3.5-2 Setting panel of the Rosslare entrance object

2. From the Number dropdown list select the number of exit (Figure 3.5-2, 1).

3. From the Type dropdown list select the corresponding type of the exit that is used (Figure 3.5-2,

2).

4. In the Active when enabled field using up-down keys set the time (in minutes and seconds)

during which the entrance is possible (Figure 3.5-2, 3).

5. To save changes click Apply (Figure 3.5-2, 4).

Configuration of entrances is completed.

3.5.2 Configuration of exits

Configuration of АС-215 controller exits is performed on the setting panel of the Rosslare exit object.

This object is created on the basis of the AC-215 controller object on the Hardware tab of the System

settings dialog box (Figure 3.5-3).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

Pas de commentaire

Rosslare AC-215 Manuel d'utilisateur Page 10