Rosslare AC-Q41H Manuel d'utilisateur télécharger pdf (Page 24)

EASYKA

When the built-in keypad heater is active it will require additional

The isabled, to

Warn

power.

factory default setting for the keypad heater is d

changing it:

1. Enter Programming Mode.

2. Press "6" to enter Menu 6: the Mode LED will flash green.

3. Construct the digit code 3 0 0 and the fourth digit as follows:

“0” to DISABLE the heater

“1” to ENABLE the heater

20. Return To Factory Default Settings

ing:

ou ust be very careful befoY m re using this command! Doing so

w cludes all Use pecial

Code

the

valid, will be

will ret e

ill erase the entire memory which in

s, and return all codes to t

r and S

heir factory defaut settings.

GREEN

RED

1. Enter Programming Mode

Press "0" to enter Menu 0:

both LEDs flash red.

3. Enter your 4-digit

Programming Code: If

Programming Code is

all memory

erased, you will hear three

beeps and the controller

urn to Normal Mod

(If the Programming Code

is invalid you will hear a

long beep and the controller will return to Normal Mode without

erasing the memory of the controller).

1 2 ... 19 20 21 22 23 24 25

Pas de commentaire

Rosslare AC-Q41H Manuel d'utilisateur Page 24