Rosslare AC-215 Guide de l'utilisateur télécharger pdf (Page 116)

Network Configuration

116 AxTraxNG™ Software Installation and User Manual

To initialize and configure the computer modem:

1. In the Network window, click Configuration.

The Modem Configuration window opens.

2. In the Dialing area, under Remote modem phone number, type the

destination telephone number to call.

3. Click to change the Number of dial attempts (if required).

For most applications, the default dialing string is sufficient.

The dialing string is displayed in the window.

4. Clear the Use default checkbox. This allows adding or editing of the

dialing string. Then, type the AT command in the Dialing string window.

5. From the Dialing schedule dropdown list, select the time zone.

6. Choose the disconnecting condition: Disconnect by schedule end or

Disconnect on upload complete.

This option is enabled when the selected time zone is different from the

default time zone (Always and Never).

7. In the Settings area, the initialization string is displayed in the window.

For most applications, the default initialization string is sufficient.

8. Clear the Use default checkbox to allow adding or editing of the dialing

string. Then, type the AT command in the Dialing string window.

9. Connect the computer's modem to the PC via the selected COM port, and

click Apply to initialize the PC modem.

10. Click OK to complete the initialization.

11. If the computer displays a failure message, check the modem connections

and repeat the last steps.

Remote modem initialization is at the PC side. When modem initialization

fails through telephone line, a message appears.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 138 139

Pas de commentaire

Rosslare AC-215 Guide de l'utilisateur Page 116