Rosslare AC-215 Guide de l'utilisateur télécharger pdf (Page 119)

Restoring Factory Default Settings

AxTraxNG™ Software Installation and User Manual 119

D. Restoring Factory Default Settings

If the modem configuration password is lost or forgotten, reset the access

control panel to the factory default settings, and use the default "VeriTrax"

password.

Restoring factory default settings resets all doors and reader configurations

to their factory defaults and clears all user properties.

To restore the factory default settings:

1. Turn off the supply power.

2. Disconnect all doors and readers wiring.

3. Connect Data 0, Data 1, and Tamper inputs to GND (-) in both reader 1

and 2 (total of six wires)

4. Power up the supply power for a few seconds. Wait for the "LED3" and

"LED4" LEDs to flash alternately.

5. Turn off the supply power.

6. Connect the doors and readers wiring again.

7. In AxTraxNG™, delete the panel by clearing the Enable panel checkbox

in the panel screen. Click OK.

8. Select the Enable panel checkbox in the panel screen and click OK. This

action causes a full reset of the access control panel with the factory

settings.

9. Dial to the appropriate access control panel and click password in the

modem status screen. Use AxTraxNG™ as the current password, and

change the password to a new one.

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 138 139

Pas de commentaire

Rosslare AC-215 Guide de l'utilisateur Page 119