Rosslare AC-Q41H Manuel d'instructions télécharger pdf (Page 27)

Programming

AC-Q4x Family, Installation and user Manual Page 26

During the manufacturing process, certain codes and settings are

pre-programmed. These settings are the called default factory

settings.

4.1 INTRODUCTION

Programming an AC-Q4x series Access Control unit is done solely

via the unit’s keypad-driven Programming Menu System. To reach

the Programming Menu System, the controller must first be placed

into Programming Mode. Refer to Entering Programming Mode,

paragraph

4. Programming

Note:

• In the Programming chapter, “code” refers to a PIN code or

proximity card depending on the unit you have.

• When entering a PIN or presenting a proximity card is

mentioned, the meaning may vary between units.

4.1.1

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 57 58

Pas de commentaire

Rosslare AC-Q41H Manuel d'instructions Page 27